The function and operation process of the gasification fan and electric heating of the material seal pump of the pneumatic conveying equipment: first, check the gasification fan and electric heater, connect the power supply, check whether the switch position of the fan pipe contact door is correct, open the fan outlet door, start the gasification fan, and open the corresponding electric heating outlet door. When the pressure of material seal pump of pneumatic conveying equipment is low, increase the air supply pressure and open all air supply valves; Repair and check the pressure gauge; Check the wiring.

檢查氣化風機和氣力輸送設備料封泵電機的地腳螺栓是否松動，皮帶罩是否牢固?？措姍C接線是否正確，接地線是否良好。氣化空氣油位應正常，冷卻水應暢通。皮帶應適度拉緊，風扇入口處的空氣過濾器不應堵塞。運行前檢查氣化風機和電加熱控制箱上的電源指示燈亮，電壓表指示正常。電加熱器外殼應完整，電源和接地線完好。檢驗合格后，可在氣力輸送設備料封泵的上位機上投入運行。

Check whether the anchor bolts of the gasification fan and the material seal pump motor of the pneumatic conveying equipment are loose and whether the belt safety cover is firm. Check whether the motor wiring is correct and whether the grounding wire is good. The oil level of gasification air should be normal, and the cooling water should be unblocked. The belt should be properly tightened, and the air filter at the inlet of the fan should not be blocked. Before operation, check that the power indicator on the gasification fan and electric heating control box is on, and the voltmeter indication is normal. The shell of electric heater shall be complete, and the power supply and grounding wire shall be intact. After passing the inspection, it can be put into operation on the upper computer of the material seal pump of the pneumatic conveying equipment.

以上就是為大家介紹的有廣西氣力輸送方案設計的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態(tài)度,為您提供服務http://tgzgw.cn/

The above is a detailed introduction to the design of Guangxi pneumatic conveying scheme. I hope it will help you. If you have any questions, please contact us. We will provide services for you with a professional attitude http://tgzgw.cn/