產養殖微納米曝氣機工作原理

Working principle of micro nano aerator for aquaculture

微納米曝氣機由主機、溶氣系統、釋放系統等組成。RWP微納米曝氣機通過主機泵將氣體和水混合后輸入到溶氣罐,使氣體溶解在水中,繼而通過釋氣裝置將溶解氣體釋放出來形成微納米氣泡,并以高速射流到水中,實現水質的凈化。微納米氣泡在水中的溶解率超過85%,溶解氧濃度可以達到飽和濃度以上,并目微納米氣泡是以氣泡的方式長時間存留在水中,可以跟隨著水流的方向全方面增氧，也可以隨著溶解氧的消耗不斷地向水中補充活性氧,讓水體不缺氧，為凈化處理污水的微生物提供了充足的活性氧、強氧化性離了團,并保證了活性氧充足的反應時間。經過RWP系列微納米曝氣機處理后還原的潔凈水,水中的溶解氧含量標準為4ppm（4毫克）,水自身的凈化能力遠遠高于自然條件下的自凈能力。

Micro nano aerator is composed of main machine, dissolved air system, release system, etc. The RWP micro nano aerator mixes the gas and water through the main pump and inputs them into the air dissolving tank to dissolve the gas in the water. Then, the dissolved gas is released through the gas releasing device to form micro nano bubbles, which are injected into the water with high-speed jet to realize the purification of water quality. The dissolution rate of micro / nano bubbles in water exceeds 85%, and the dissolved oxygen concentration can reach above the saturation concentration. The micro / nano bubbles are kept in the water for a long time in the form of bubbles, which can increase oxygen in all aspects with the direction of the water flow. They can also continuously supplement active oxygen to the water with the consumption of dissolved oxygen, so that the water body is not anoxic, providing sufficient active oxygen and strong oxidizing dissociation for microorganisms purifying and treating sewage, The reaction time of active oxygen is sufficient. The dissolved oxygen content of the reduced clean water treated by RWP series micro nano aerators is 4ppm (4mg), and the purification capacity of the water itself is much higher than that under natural conditions.

水產養殖微納米曝氣機安裝注意事項：

Precautions for installation of aquaculture micro nano aerator:

微納米曝氣機的特點就是在安裝的時候非常的方便，根據圖紙的要求非常簡明、易懂，不需要安裝的基礎，電源線的安裝需要的電工來進行。

The feature of micro nano aerator is that it is very convenient to install. According to the requirements of the drawings, it is very concise and easy to understand. There is no need to install the foundation. The installation of power lines requires professional electricians.

水底的距離跟電機在水表面上工作的區域水深不得少于1.5米

The distance between the underwater bottom and the water depth of the area where the motor works on the water surface shall not be less than 1.5m

微納米曝氣機安裝說明書的要求安裝在水底或岸邊，在對稱位置用膨脹釘設置兩個適宜的固定點用拉索固定，拉鎖的另一端頭連接在納米氣泡機的浮筒上將機器安放在水體的合適位置將拉索固定即可。

The micro nano aerator shall be installed at the bottom of the water or on the bank according to the requirements of the installation instructions. Two suitable fixing points shall be set at the symmetrical position with expansion nails and fixed with cables. The other end of the latch shall be connected to the pontoon of the nano aerator. The machine shall be placed at a suitable position in the water body to fix the cables.

電源線選擇可移動的橡套防水電纜，其中一芯與電機外殼可靠接地。

The movable rubber sheathed waterproof cable shall be selected as the power line, and one core shall be reliably grounded with the motor shell.

安裝深度不可隨意調節。

The installation depth cannot be adjusted at will.

安裝完之后要檢測電機的運轉方向是否正確，如果是反方向，請及時改正。

After installation, check whether the running direction of the motor is correct. If it is in the opposite direction, please correct it in time.

工作池內不得出現金屬線、繩子等易纏繞的雜質

There shall be no metal wire, rope and other impurities that are easily entangled in the working pool

微納米曝氣機在出廠時有專門的電器控制系統

The micro nano aerator has a special electrical control system when it leaves the factory

本文的精彩內容由湖北水產增氧設備提供知識提供，本網站還有很多的精彩內容，更多的內容您可以點擊進入：http://tgzgw.cn/我們有專門的客服為您解答問題

The wonderful content of this article is provided by Hubei aquatic oxygenation equipment. There are many wonderful content on this website. You can click to enter more content: http://tgzgw.cn// We have special customer service to answer your questions